Thermostat
Model TZEMT500AB32MAA
Installation Instructions
NOTE:
This thermostat is not compatible with dual
fuel systems (heating system with both heat pump and
gas or oil furnace), unless the system is controlled with
a dual fuel accessory relay kit.
1
WARNING
Voltage hazard. Can cause electrical shock or equipment damage. Disconnect power to
heating and cooling equipment before beginning installation.
2
Remove the existing thermostat cover from the wall plate.
Leave wires attached.
Consult instructions that came with existing thermostat as needed.
Wall plate
Thermostat cover
The look of the existing
thermostat may vary
Physical Installation and Wiring
1
NOTE:
A 24 Volt common and hot wire
MUST be
connected to the TZEMT500 for operation.
18-HD39D1-1
MERCURY NOTICE
When this control is replacing an old control that contains mercury in
a sealed tube, do not dispose of your old control in the trash. Dispose
of properly. Contact your local waste management authority for
instructions regarding recycling and proper disposal of the old control.
A listing of heating, ventilating and air conditioning wholesalers that
participate in the Thermostat Recycling Corporation’s recycling
program are available at www.thermostat-recyle.org .
The TZEMT500 Thermostat
is compatible with single and
multistage forced air systems, including:
•
Gas furnace systems
•
Oil furnace systems
•
Electric furnace systems
•
Heat pump systems
•
Air conditioning systems
The TZEMT500 Thermostat
may be compatible with some
other system types, including:
•
Boiler systems
•
Geothermal systems
•
Multi-zoned systems
The TZEMT500 Thermostat
is not compatible with the
following system types:
•
Radiant floor systems
•
Wall heating systems
•
Propritary HVAC Communication Protocols
The TZEMT500 Thermostat
is not compatible with dual
fuel systems (gas or oil furnace & heat pump combined)
without adding a special kit. See Note below.
Schlage LiNK
TM
Customer Service: (877) 288-7707
Table of Contents
Physical Installation and Wiring
Pages 1-11
Field Wiring Diagrams
Pages 7-9
Remote Temperature Sensors
Page 10
System Settings at Thermostat
Pages 12-13
Perform System Checkout
Pages 14
Enroll Thermostat into Schlage LiNK
TM
System
Pages 15-16
Product Specifications
Page 17
Operation
Pages 18-19
Menu Maps
Page 20
User Settings
Pages 21-28
Installer Settings
Pages 29-31
Schedules
Pages 32-34
LED Reference
Page 34
