Trane TXK, Installation Operation & Maintenance

Page: 4 / 30

MS-SVX10A-EN 4
Safety Precautions
WARNINGS
All phases of this installation must comply with National, State and Local codes.
This information is intended for use by
individuals possessing adequate backgrounds
of electrical and mechanical experience. Any
attempt to repair a central air conditioning
product may result in personal injury or
property damage. The manufacturer or seller
cannot be responsible for the interpretation of
this information, nor can it assume any liability
in connection with its use.
NOTICE:
Trane has always recommended installing
Trane approved matched indoor and outdoor
systems.
The benefits of installing approved matched
systems are maximum efficiency, optimum
performance and best overall system reliability.
These units use R410A refrigerant which
operates at 50 to 70% higher pressures than
R-22. Use only R-410A approved service
equipment. Refrigerant cylinders are painted
a “rose” color to indicate the type of
refrigerant and may contain a “dip” tube to
allow for charging of liquid refrigerant into
the system. All R-410A systems use a POE
oil that readily absorbs moisture from the
atmosphere. To limit this “hygroscopic”
action, the system should remain sealed
whenver possible. If a system has been open
to the atmosphere for more than 4 hours, the
compressor oil must be replaced. Never
break a vacuum with air and always change
the driers when opening the system for
component replacement. For specific
handling concerns with R-410A and POE oil,
reference Retrofit Bulletin TRN-APG02-EN.
UNIT CONTAINS R-410A REFRIGERANT!
R-410A OPERATING PRESSURE EXCEEDS
THE LIMIT OF R-22. PROPER SERVICE
EQUIPMENT IS REQUIRED. FAILURE TO USE
PROPER SERVICE TOOLS MAY RESULT IN
EQUIPMENT DAMAGE OR PERSONAL INJURY.
SERVICE
USE ONLY R-410A REFRIGERANT AND
APPROVED POE COMPRESSOR OIL.