6
18-GJ06D2-2A
The Coil, Line Set, and Heater panels are removed using Phillips head
screws.
Removal requires #3 Size Phillips
Coil and Heater panels must be removed prior to removing the Line
Set panel.
To remove Coil Panel:
1.
Turn screws on Coil panel.
2.
Pull bottom of panel out, away from cabinet.
3.
Pull panel down and out of channel.
4.
Set aside.
To remove Heater Panel:
1.
Turn screws on Heater panel.
2.
Pull panel straight out, away from cabinet.
3.
Set aside.
0 0
0
0
Removal of the Line Set panel is required for all refrigerant line brazing
and some condensate line assembly depending on your orientation.
To remove Line Set panel:
1.
Remove both Heater and Coil panels.
2.
Turn screws on Line Set panel.
3.
Pull panel straight out, away from cabinet.
4.
Set aside.
Note:
After replacing all panels, loosen the Line Set panel screws
approximately 1/4 — 1/2 turn. This will improve the seal
between the Heater Panel and Line Set panel.
