General Information
6
RT-SVN16B-EN
b. Remove the recessed hinge screw from the left
hand bottom end of the panel.
c. Unlatch the door of the enclosure as if to open it,
and slide the left hand side of the door upward away
from the hinge; Lay it aside.
d. With the Key Pad visible, remove the two (2) screws
located on the right hand side of the Key Pad.
e. Carefully slide the Key Pad plate upward from the
bottom, releasing the extruded hinge pin from its
socket at the top.
f. Set the microprocessor aside until mounting is
complete.
3. Remove the handy box knockout in the back of the
enclosure.
Note:
The top of the enclosure is marked “TOP”. With the
enclosure in the correct position;
4. 4. Align the mounting holes around the knockout in the
enclosure with the screw holes in the electrical handy
box and secure with the appropriate screws.
5. 5. Replace the microprocessor within the enclosure as
follows:
a. Verify that the jumpers for terminal blocks J-5 and
J-6 are both connected to terminals 2 and 3.
b. Slide the extruded hinge pin at the top left of the Key
Pad plate into the hole located at the top left hand
side of the enclosure.
c. Slide the bottom of the plate into place, aligning the
two (2) clearance holes with the screw holes on the
right. Install the screws but do not tighten at this
time.
Note:
If the two screws are not installed as called out in
the previous step, hold against the Key Pad plate
while installing the door in the next step, to prevent
it from falling out.
d. Slide the extruded hinge pin at the top left of the
door into the hole located under the bottom left side
of the display.
e. Install and tighten the hinge screw located at the
bottom left side of the enclosure.
Wall Mounting the Remote Panel
Prior to mounting the panel, the microprocessor module
must be removed from the enclosure. Complete step 2 in
the previous discussion, “Mounting on a 4" x 4" Electrical
Box” before proceeding.
1. With the Microprocessor removed, refer to
for the location of the mounting holes to be used
for wall mounting.
2. Place the enclosure against the mounting surface and
mark the mounting holes.
Note:
The top of the enclosure is marked with “TOP”. With
the enclosure in the correct position:
3. Remove the enclosure and drill the necessary holes in
the surface for the appropriate fasteners, (plastic
anchors, molly bolts, screws, etc.)
4. Remove the necessary knockouts for the wire or
conduit entry before mounting the panel.
5. Place the enclosure back onto the surface and secure it
with the appropriate screws.
Summary of Contents for IntelliPak S HJ Series
Page 11: ......
