46
MUA-SVX004B-EN
Gas Equipment Start-Up
Customer
____________________________________
Job Name & Number
_________________________
Type of Equip:
Unit Heater
Rooftop
Serial Number
_________________________ Model Number __________________________
Name Plate Voltage:
_____________
PRE-INSPECTION INFORMATION
With power and gas off.
Duct Furnace
Indoor
Name Plate Amperage: _____________
LP
Type of Gas:
Natural
Rating: ______ BTU @ ____ °F
Tank Capacity ______ lbs.
______ kw @ ____ °C
______ kg
Are all panels, doors, vent caps in place?
Damage ______________________________
Has the unit suffered any external damage?
GENERAL
(DO NOT START this equipment unless you fully understand the controls.)
Does the gas piping and electric wiring appear to be installed in a professional manner?
Has the gas and electric been inspected by the local authority having jurisdiction?
Is the gas supply properly sized for the equipment?
Were the installation instructions followed when the equipment was installed?
Have all fi eld installed controls been installed?
Do you understand all the controls on this equipment?
If not, contact your wholesaler or rep.
BLOWER
GAS HEATING
With power and gas off.
Make certain all packing has been removed.
Tighten all electrical terminals and connections.
Check damper linkages for tightness.
Check all fans & blowers for free movement.
Check all controls for proper settings.
Check all set screws on blowers and bearings.
Check belt tightness.
With power on and gas off.
Check voltage L1 _____ L2 _____ L3 _____
Check rotation of main blower.
Check motor amps L1 _____ L2 _____ L3 _____
Blower RPM _____________
Check air filters (Record quantity & size.)
With power and gas on.
Inlet gas pressure.
____ in. W.C. or ____ kPa
Pilot & main burner ignition.
Manifold gas pressure. ____ in. W.C. or ____ kPa
Cycle on HIGH LIMIT.
Cycle fi restat and/or freezestat.
Check electronic modulation. Set at: __________
Cycle and check all other controls not listed.
Check operation of remote panel.
Entering air temp. _____ °F or ____ °C
Discharge air temp. (high fi re) ____ °F. or ____ °C
External static pressure ____ in. W.C. or ____ kPa
Cycle by thermostat or operating control.
Combustion Reading.
Carbon Mononxide ______ PPM
Carbon Dioxide ______ %
