Installation
64
WSHP-SVX01Q-EN
9. Wire-tie the sensor to the water SUPPLY side of the
piping (ON, or BEFORE) the 2-position valve. See
Figure 74, p. 64
.
10. Bundle excess sensor wire, and wire tie the bundle
neatly. See
Figure 75, p. 64
.
11. Thread the valve’s wire lead through the low voltage
hole of the heat pump. See
Figure 76, p. 64
.
12. Wire the valve to the terminal strip according to the
unit wire diagram located on the service control panel.
RED = 1TB1-14
BLK = 1TB1-18
WHT = 1TB1-15
See
Figure 77, p. 64
.
13. Bundle excess valve wire, and wire tie the bundle
neatly. See
Figure 78, p. 64
.
14. Install control side service panel.
15. Install the hanging isolation grommets (see
Figure 79,
p. 64
) into the hanging bracketsThe unit isolators were
located in the return-air section of the unit. See
Step 2
.
Isolators for the economizing package are located with
the economizer.
Note:
GEH .5-5 ton and EXH .5-6 ton.
Figure 74.
Step 9
Figure 75.
Step 10
Figure 76.
Step 11
Figure 77.
Step 12
Figure 78.
Step 13
Figure 79.
Step 15
