6
RT-SVN13A-EN
Installation
Note:
Once all the screws are removed, the top cover plate and the module will be free from the
mounting plate. Remove and discard the Heat Module Cover Plate.
3. Disconnect the wires from one end of the Heat Module by unplugging the connectors. Move
the module away from its mounting plate.
4. Using 4 #6-32 x 3/8 inch mounting screws from the kit, align the mounting holes in the BCI-I
Mounting bracket with the holes in the Heat Module mounting plate. Refer to (
-
) for proper orientation.
5. Replace the Heat Module onto its mounting plate and install the four screws removed in
. Reconnect all wiring plugs to their appropriate terminals.
6. Using 2 #6-32 x 3/8 inch screws and 2 #6 TYPE A washers from the kit, install the DIN rail for
the BCI-I Module as shown in (
).
7.
Using 2 DIN rail end stops from the kit, install the module onto the DIN rail. Refer to
for DIN rail mounting/removal.
Note:
For IntelliPak factory-installed mounting, refer to
.
IntelliPak II - Module Installation
1.
Disconnect all power from the Rooftop or Air Handler Unit.
2. Using 2 #10-32 x 1/2 inch screws from the kit, install the DIN rail for the BCI-I Module as shown
in
.
3. Using 2 DIN rail end stops from the kit, install the module onto the DIN rail. Refer to
for DIN rail mounting/removal.
Figure 1.
BCI-I Controller board
