www.TrailFX.com
Page
3
of
11
Rev 062816
5. Over rail Bedliner Installation Steps
Tailgate Cover Installation Steps with Factory Screws
STEP 1
With the Bedliner Out Of Truck:
1.
Assemble "Liner-
Lok™" fasteners by sliding metal
clip onto plastic swingnut (see FIGURE 1).
2.
Insert screw through hole provided in bedliner side
wall, with head of screw toward inside of truck bed.
3.
Position "Liner-
Lok™" fastener with side "A" towards
screw tip (see FIGURE 2).
4.
Insert screw tip into hole and metal clip of fastener
and turn one or two rotations, or until tip of screw in
engaged into fastener.
IMPORTANT
: The "Liner-
Lok™" must be in a loose downward-hanging
position at this time. (see FIGURE 5)
5.
Repeat “Liner-Lok™" fastener assembly to remaining
holes.
STEP 2
Place bedliner with loosely hanging "Liner-
Lok™" fasteners
into truckbox. Pull the bedliner rails away from truck rails and
push downward starting at front corner, until forward "Liner-
Loks™" slip under the truck rails. Make certain that all "Liner-
Lok™" fasteners have slipped under the truck rails before
tightening (see FIGURES 3, 4 & 5).
STEP 3
Close tailgate. Adjust bedliner if needed.
STEP 4
Standing or kneeling on bedliner in truck box:
1.
Start at either front (cab end) corner and push
downward on bedliner rail while turning screw
clockwise with screw driver (see FIGURE 6). You
should "feel" the "Liner-
Lok™" pivot upwards and
stop. Continue turning the screw clockwise until tight
(see FIGURE 7).
2.
Move to opposite corner and repeat step 4 - 1.
3.
Repeat step 4 - 1 to remaining "Liner-
Loks™".
STEP 1 (Figure 1)
Place bedliner in the truck bed, such that the front rail retainer fits over the front rail of the truck bed. While standing on the side
of the truck, lift one side of the bedliner and slip the sidewall of the bedliner under the opposite wall of truck box.
STEP 2 (Figure 2)
While standing at the rear of the truck, lift the bedliner floor in the center. (FIGURE 2) This procedure allows the bedliner sidewall
to rotate away from the bed rail. Have a 2nd person slip/lock the bedliner sidewall in position by applying a downward force.
NOTE: Make sure that the raised liner locking tabs on the sidewalls are secured behind and under the side rail sheet metal of the
truck box.
STEP 3
Check the overall fit. It is important that the bedliner fits securely in place under the bed rails. If necessary, repeat steps 2 & 3.
