www.TrailFX.com
Page
1
of
11
Rev 062816
30-60 min
DRILLING
REQUIRED
CUTTING NOT
REQUIRED
DO NOT OVER
TORQUE
.
STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM
45
TO
65
FOOT POUND.
Tools Required
#40 Torx Head Driver,
Phillips Screwdriver
Power Screwdriver with Phillips Bit
1/2" & 13 mm Socket Wrench
1/8" drill bit.
1. INSTALLATION PROCEDURE:
WARNING:
Do not transport a pickup truck facing backward with a liner installed.
Air can get under the liner which may result in the liner coming out of the truck and causing damage or injury.
Truck Box Preparation:
Clean truck box of all foreign matter and open any floor drains to ensure ventilation and moisture drainage.
NOTE:
Bed liner can be installed by one person. However, using two people is recommended by the manufacturer.
2. Tailgate Cover Installation Steps with Screws
NOTE:
Your tailgate cover kit may have more or less hardware than shown. Toyota & Isuzu tailgate does not use latch screws.
`
GM BEDLINER/TAILGATE COVER
Part No. TG03X
, TG14X, TG18X
Do not over tighten as screws can be stripped out.
Limited Lifetime
1 866 638 4870
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
STEP1
Remove the 2 existing factory installed screws from tailgate
latch plate and discard.
STEP2
Center plastic tailgate cover on truck tailgate. Insert and
tighten the two screws provided in the kit in the two center
holes of tailgate.
STEP 3
Center a self-drilling screw in a pre-drilled hole in the tailgate
cover. Fasten the screw to the tailgate with a power
screwdriver. (see FIGURE 1)
Do not over tighten because the screw threads can be
stripped easily.
STEP 4
Repeat Step 3 to remaining hole locations until all are
completed.
