An excessive overload could cause the motor to
overheat. Refer to replacing the fuse instructions of this
manual. Correct the conditions that caused the fuse to
burn out and avoid repeatedly burning out fuse.
Motor or electrical switch
damage.
Contact the authorized service center for diagnosis and
repair.
Short run time less than
15 minutes per charge
Undercharged battery
Charge the battery. A new battery should have been
charged for 4-6 hours before using the vehicle.
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the charger connector,
and that the charger is plugged into the wall.
Make sure power flow to the wall outlet is on.
Battery is old and wil not
accept full charge.
Even with proper care, a rechargeable battery does not
last forever. Average battery life is 1 to 2 years
depending on vehicle use and conditions. Replace only
with a replacement battery.
Brakes are not adjusted
properly
Refer to brake adjustment instructions.
Vehicle runs Sluggishly.
Driving conditions are too
stressful.
Use only on solid, flat clean and dry Surfaces such as
pavement or level ground.
Tyres are not properly
Inflated.
The tyres are inflated when shipped, but they invariably
will lose some pressure between the point of
manufacturing and your purchase. Refer to tyre
instructions to properly inflate tyres.
Vehicle is overloaded.
Make sure you do not overload the vehicle by allowing
more than one rider at one time, exceeding the
maximum weight limit, going up too steep a hill or
towing objects behind the vehicle. If the vehicle is
overheated, the temperature circuit protector will slow
motor down and if the condition continues, will shut off
power to the motor. Correct the driving conditions that
caused the overheating, wait 5-10 minutes and then
resume riding. Avoid repeatedly overheating the unit.
Sometimes the vehicle
doesn’t run, but other
times it does.
Loose wires or connectors
Check all wires around the motors and all connectors
to make sure they are tight.
Motor or electrical Switch
damage.
Contact the authorized service center for diagnosis and
repair.
