Trafox SUPERINTEND IM-01.IND, Instructions For Installation And Use Manual, Page: 43 / 50

Superintend IMD © Copyright Muuntosähkö Oy - Trafox 43
http://www.trafox.fi
allowed value of the device
parameter
30 R The nominal value of the
current transformer, the device
parameter resolution (jog) uint16 A 5
31 R Alarm delay, the lowest allowed
value of the device parameter uint16 s 1
32 R Alarm delay, the highest
allowed value of the device
parameter uint16 s 30
33 R Alarm delay, the device
parameter resolution (jog) uint16 s 1
34 R Status register of the
unacknowledged alarms of the
device uint16 none Bit mask:
0x0001 = a fault or alarm related to insulation
resistance is inactivated, corresponds to the
INSULATION alarm LED of the local user interface
0x0002 = insulation resistance pre-alarm deactivated
0x0004 = system test fault deactivated
0x0008 = fault in the M1 or M2 wire deactivated
0x0010 = fault in the TG or MG wire deactivated
0x0020 = load alarm deactivated
0x0040 = PE fault deactivated
0x0080 = temperature alarm deactivated
the statuses will activate when the corresponding
active alarm has been deactivated and remain active
until the cause has been acknowledged
35 R PE units in the network uint16 none Bit mask: PE addresses 0…15, the corresponding bit
is active if the PE unit has been approved in the
network
36 R PE#00 configuration uint16 none Bit mask:
bit8 = if 1, the device is approved in the network
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel is in use
37 R PE#00 status uint16 none Bit mask:
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel alarm is active
bit8…13 = PE unit channels CH1…CH6: if 1, the
channel alarm has been deactivated but not
acknowledged
38 R PE#01 configuration uint16 none Bit mask:
bit8 = if 1, the device is approved in the network
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel is in use
39 R PE#01 status uint16 none Bit mask:
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel alarm is active
bit8…13 = PE unit channels CH1…CH6: if 1, the
channel alarm has been deactivated but not
acknowledged
40 R PE#02 configuration uint16 none Bit mask:
bit8 = if 1, the device is approved in the network
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel is in use
41 R PE#02 status uint16 none Bit mask:
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel alarm is active
bit8…13 = PE unit channels CH1…CH6: if 1, the
channel alarm has been deactivated but not
acknowledged
42 R PE#03 configuration uint16 none Bit mask:
bit8 = if 1, the device is approved in the network
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel is in use
43 R PE#03 status uint16 none Bit mask:
bit0…5 = PE unit channels CH1…CH6: if 1, the
channel alarm is active
bit8…13 = PE unit channels CH1…CH6: if 1, the
channel alarm has been deactivated but not
acknowledged