6
6
6
Operating Procedure
1. Make sure that you read instructions before attempting to operate your unit.
NOTE: 4 ohms and 8 ohms speakers cannot be connected to the speaker terminals at the same time!
Make sure your amplifi er is properly connected to a high-current power receptacle.
3. WARNING
. Always take care volume control is in the proper position. The amplifi er will be fully functional
after only a couple of minutes. However, as it warms up over the fi rst 30 minutes of operation you may notice
slight improvement in the sound quality.
4. At the end of your listening session make sure to turn the amplifi er off.
Leaving it on does nothing for sound quality and it reduces life of the vacuum tubes.
The amplifi er should always be turned on and off via its own power on-off switch.
The amplifi er should always be turned on and off via its own power on-off switch.
2. Attach the audio sources and speakers (refer to the picture below).
Never run the amplifi er without speakers connected since that may damage the transformers.
Speaker’s minus terminal should be connected to the speaker terminal marked as zero (0) and positive termi-
nal should be connected to the terminal that corresponds to the speaker’s nominal impedance (4 or 8 ohms).
The amplifi er is optimized for these impedances. Higher or lower impedance will result in higher distortion or
loss of power. Do not use a speaker with impedance lower than 2 ohms on either of the outputs.
Make sure to prevent short circuit at the amplifi er’s speaker terminals as that will damage the amplifi er.
Trafomatic Audio
Trafomatic Audio
66
6
6
6
6
6
6
Trafomatic Audio
Experience Elegance
Trafomatic Audio
Trafomatic Audio
Figure 2:
Experience Elegance Integrated Front panel
Figure 3:
Experience Elegance Integrated amplifi er speakers connection
Integrated Stereo Tube Amplifi er
