TrafFix Scorpion II METRO TL-2 PLUS, Assembly Manual And Mounting Instruction Manual

Page: 43 / 54

P/N 13089 Rev A1 Dated 5/13/2020 39
Step 1
Be sure that the Hook
on the TMA side is
above the Pin on the
Truck Side. Adjust ac-
cordingly if necessary.
With the securing Pins
and Clips removed from
the Truck side, push the
TMA up to the Truck
Mount.
Step 2
Using the Swivel
Jacks, lower the TMA
until the hook is fully
engaged on the top
Pin of the Truck
Mount.
Step 4
Once the TMA is fully
loaded on the Truck
Mount top Pin, store
away the Swivel Jacks
and secure the TMA
with the Pins and
Clips.
Step 5
Now that the TMA
is fully secured on
the Truck, use the
controls to lift the
TMA high enough
to store the Drop
Jacks. Once these
Jacks are stored,
the TMA is ready
for the road.
This is what the TMA should look like when it is not installed onto a Truck, see Figure 6. All Jacks should be deployed
and secure prior to installing the TMA onto a Truck. The Truck mounting side of the TMA should be high enough such
that the hooks can go over the pins on the Truck
- side mount, but the Truck side should be lower than the rear of the
TMA by a couple of degrees. This can be achieved by adjusting the Drop Jacks prior to removal of the TMA from the
truck to expose one yellow hole below the black Drop Jack Bracket and then use the Swivel Jacks until an appropriate
angle and height is achieved.
Figure 7: Step - by - Step Process on how to mount FTSC onto Traks
Figure 6: Display of Fast - Trak Swift Connect mounted onto TMA
Step 3
Momentarily push
the “Up” button on
the 2 - Button
Controller until the
bottom of the TMA
Side is against the
bottom of the Truck
Side.