Installing Lead Acid Batteries in SafePace Evolution Signs
2.
Gently place the battery, on its side in the lower bracket and lay the battery flat against the enclosure.
3.
Place the upper bracket on top of the battery and align the screw holes in the bracket with the screw
holes in the enclosure.
4.
Use the included screws to screw the bracket into place. Make sure not to over tighten the screws.
5.
When the battery is secured in the battery bracket, connect the battery and sign power connectors to
power on the sign.
6.
When you are finished, you can close and latch the sign enclosure.
W
ARNING
:
It is vitally important, whenever you close the sign, that you close and lock
all
of the latches
properly to avoid water infiltration as this could damage the sign and void your warranty.
SafePace® Evolution11 Installation Guide
p. 25
