Traeger BBQ150.01, Owner'S Manual

Page: 4 / 24

SECTION ONE: ASSEMBLY INSTRUCTIONS
Steps 1 through 7 below do not apply if you intend to use your Grill in a built-in
application.
MOUNTING THE LEG FRAME ASSEMBLIES AND CASTERS
The assembly process will require two people to complete.
1) With your helper, carefully lay the Grill on its back on a non-abrasive surface.
2) The 2 Leg Frames (21) will mount on each side of the Grill, running front to back.
3) Using the 7/16 Wrench, attach the Leg Frames (21) to the Grill. 2 Hex Head Bolts (26) and
2 Washers (27) are needed for each Leg Frame (21). Do not over tighten.
4) Attach a Leg Brace (22) to the Front Legs. Use 4 Phillips-head Screws (25). Do not over
tighten.
5) Install the Casters (23, 24). The Locking Casters (24) are to be located on the front of the
Grill (Door Side). Slip a Caster Stem fully into the Leg. Turn the Tensioning Ring at the
bottom of the Caster Stem to tighten, which expands the Compression Bushing and
secures the Caster in the Leg. Repeat this process on the remaining Legs.
6) With your helper, stand the Grill upright.
7) Attach a Leg Brace (22) to the Rear Legs. Use 4 Phillips-head Screws (25) 4.
Do not over
tighten.