6) Re-tighten the 7/16 bolts, making sure that the Auger End Piece Shaft still freely
rotates over the Auger Drive Motor shaft.
7) Reinstall the screw and nut connecting the Auger Drive Motor shaft to the Auger
shaft.
WITH THE TRAEGER DIGITAL CONTROL, WHAT DIAL SETTING IS
RECOMMENDED FOR STARTING THE GRILL?
The auto-start procedure is the same for all Grill Controls. With the Door open, turn
the Switch/Dial ON and Temperature Dial to SMOKE. In approximately 2 minutes
you will notice whitish-gray smoke coming out of the Grill as the Pellets ignite. After
assuring the Pellets have ignited, close the Door and set the Temperature Dial to
any cooking setting desired.
HOW DO I PROTECT MY PAINT FINISH?
1) Use a protective Cover on the Grill and touch-up paint to repair any scratches.
A
TRAEGER GRILL COVER to protect the Grill is highly recommended! Covers
and touch-up paint are available from your local Traeger Dealer, or log on to
our Web Site –
www.traegergrills.com
.
2) Every 90 days, use a high quality car wax on the outside surfaces of the Grill. ONLY
APPLY WAX TO A COLD GRILL.
WHERE CAN I GET A NEW PART FOR MY GRILL?
Check with your Traeger Dealer. They may have the part in stock or can order the part
for you. Or you can contact the Traeger Parts Department
(SECTION SEVEN)
to place
an order. In either case, please provide your name, phone number, address, Model and
Serial Number of the Grill (located on a label inside the Hopper Lid), along with the part
identification.
