15
A3380002.en_teil2
12 CLEANING
In case of heavy dirt and when painted straps are used the punch, dies, gripper and feed-wheel must be
cleaned regularly.
Normally it is sufficient to blow out the parts with the help of an air gun.
13 EXCHANGE OF WEARING PARTS
Exchange of the feed wheel and the gripper
•
Disassemble cylinder screw in the end plate.
•
Lift the rocker and remove end plate, strap guide, supporting disk and feed wheel from the tension shaft.
•
Unscrew holder and remove it together with the gripper from the base plate.
•
Fitting in opposite order.
Important!
The fastening screw for the holder has to be secured with LOCTITE 222.
Observe assembling position of the feed wheel
Gripper
Holder
Strap guide
Supporting disk
Feed wheel
Rocker
End plate
Sales and Service 877-862-6699
WWW.TRADITIONALTOOL.COM
