Tractel 192319, Instructions For Use Manual, Page: 13 / 36

M 6116 M
rev 8 – 12/2017 p. 13 / 36
GB
ƒ TRACTEL SOLUTIONS SAS is at your disposal in order to conduct any regulatory check.
⋅ Before each use
ƒ
Visually inspect all pulley components
ƒ
Control location and condition of safety latch (DB50 model) and safety device pin.
ƒ Check for wobble and excessive clearance in the sheave and free rotation before each use.
ƒ Check the rope and the wedge and make regularly tests of the safety device with hoisted loads.
⋅
Complete inspection
ƒ
According to French regulation, pulleys must be checked each year. This annual control must
include all necessary examinations in order to detect any damage or potential problems that
could cause dangerous situations.
ƒ Check if equipment doesn’t have any deformation, cracks or other defaults.
ƒ Check for excessive backlash and wear, especially for the safety device
ƒ Verify groove of the sheave for wear and tear
ƒ Ensure that there are no cracks and no deformation on the hook latch (DB50 model), proper fit
and operation.
ƒ
Inspection of the suspension:
o
Check for the latch (DB50 model),
o
No deformation of the flanges, hook (DB50 model) or the ring (DB51 model),
o
Check for missing pins, nuts
ƒ Check presence and legibility of engraved information or signaling plate.
ƒ Note all controlled information on a register
STORAGE AND MAINTENANCE
⋅ Storage
ƒ It is advisable to remove the rope from the pulley for its storage.
ƒ Correctly store the instructions for use with the pulley.
ƒ
Keep the material in a dry place, protected from bad weather.
ƒ Ensure that the pulley is stored with no loads attached.
⋅ Functioning anomalies
ƒ
The sheave rotation must be free
ƒ
No wobble and excessive clearance in the sheave.
ƒ The wedge must be free
⋅
Maintenance of the equipment
All maintenance inspections and operations must be performed by qualified and trained specialists
The POULISTOP2 is made of zinc plated steel and plastic, protecting it for normal use in outside
construction activities.
As all the Tractel Solutions products, it is manufactured without bearing welds, reducing inspections
before use to their minimum.
Spare parts (rope and wedge) are available from Tractel Solutions.
Those parts should be replaced immediately when wear appears.
Tractel Solutions stays at your disposal.