Trackmaster TMX58, Owner'S Manual

Page: 26 / 66

Set-up Instructions TRACKMASTER
5-4 TMX58 Owner’s Manual August 2013
Le TRACKMASTER
®
est conforme à FCC classe A d'avis pour les émissions
électromagnétiques. Il est recommandé de ne pas placer le tapis roulant à moins de 5 pis.
(1.5m) à partir d'appareils électroniques sensibles dans la chambre ou dans une salle
adjacente. Si un problème d'interférence, déplacer le tapis roulant plus loin du dispositif
sensible ou déplacer soit appareil à un autre domaine, ou consulter un spécialiste EMI
des moyens pour protéger la chambre de rayonnement électromagnétique.
Ne le placez pas sur un tapis épais ou longs poils. Un tel tapis pourrait entraîner une
instabilité ou accumulation d'électricité statique, et les fibres de tapis pourrait se coincer
dans le tapis et endommager l'appareil.
Assurez-vous que les cordons d'alimentation ne traversent pas les zones de circulation.
Cordons d'alimentation exposées risqueraient de provoquer une chute, entraînant des
blessures.
Tenir à l'écart de toute source d'humidité, comme des spas ou des fontaines
.
L'humidité peut provoquer le circuit électronique de dysfonctionnement .
Final Setup - Running Belt Tracking Adjustment
NOTE:
Because this adjustment is not covered under your warranty, it is important that you review
these instructions thoroughly before proceeding. Uneven floors accelerate belt
misalignment. This situation may require more frequent adjustment to prevent belt damage.
The patented MasterTrack
®
Belt Tracking System significantly reduces the need to adjust the belt
on your TRACKMASTER
®
. However, when you operate your treadmill for the first time, you
may need to adjust the tracking of the belt to conform to your floor. You may also need to adjust
the tracking if you move the machine to another location. (See Preventative Maintenance chapter
7 for adjustment procedure.)
Final Setup - Running Belt Tension Adjustment
Your TRACKMASTER
®
running belt has been pre-tensioned at the factory and run for 16 hours
prior to shipment. It may, however, be necessary to adjust the belt tension when the treadmill is run
in its final location. A loose belt tends to hesitate or stick with a heavy foot plant. If your belt needs
tensioning, the adjustment procedure can be found in Preventative Maintenance chapter 7.
NOTE:
Improper adjustment could cause the treadmill to hesitate and cause a trip and fall hazard.
Because this adjustment is not covered under your warranty, it is important that you
review these instructions thoroughly before proceeding.
Final Setup - Drive Belt Tension Adjustment
The drive belt tension has been set at the factory and is self adjusting to minimize
maintenance. This design will compensate for initial stretch of the drive belt and not
require further adjustment. If the belt becomes stretched and loose, refer to the
Preventative Maintenance chapter 7 for adjustment procedure.
NOTE
: Because this adjustment is not covered under your warranty, it is important that you
review these instructions thoroughly before proceeding.