ISSUE DATE 06/15/01 REV. DATE
REV. NO. 00 ECO NO. 1-4635 P/N 00009979 SHT. 03 OF 09
MOUNTING CONFIGURATIONS
All Angle Heater Series offers a selection of air inlet and discharge arrangements.
Inlet and outlet grille arrangements are easily altered by opening front panel of unit
and removing (2) screws.
Heaters Cannot be
mounted on the
END!
NOTE: Semi recessed to be recessed
3 ½ “ maximum unless both
inlet and outlet grilles are to the
front.
SEMI RECESSED
FULLY RECESSED
SEMI RECESSED
SEMI RECESSED
MOUNTING CLEARANCES
Proper clearances are indicated for each mounting configuration. In all positions,
clearance from end of heater to a side wall is zero inches.
Mounting holes are provided in the back of the cabinet, accessible through the blower
compartment. If necessary, remove blower deck if additional mounting screws or
bolts are desired. Blower deck may be slipped forward by loosening four screws at
the front to provide access to mounting holes.
KEY
W
6” minimum
X
12”minimum
Y
0 or greater
Z
24”minimum
V
48”minimum
UP FLOW
DOWN FLOW
Unit may be mounted upside down to
reverse direction of air flow.
A
B
W
C
D
Y
A
D
W
Y
D
Y
A
C
Z
B
D
X
A
Z
X
D
D
X
A
W
V
W
B
V
C
Y
V
Y
V
D
W
A
V
D
Y
V
D
Y
V
A
B
C
D
A
B
C
D
A
B
C
D
D
D
D
D
A
A
UP FLOW
WALL
CEILING
DOWN FLOW
