5.3 WINDING AND VIEW WINDOW
These are two basic windows, in which we can start programmed cycle.
Repeated pressing of the ENTER-button caused the switching.
Winding window - provided actual information about winding process
View window - displayes the view of programmed step parameters
Winding is possible only in these two windows. If any other window is opened, the cycle start
is blocked.
5.4 EXPLANATION OF CONCEPTIONS STANDSTILL, START, STOP
STANDSTILL: State after switching on the machine and pressing ENTER, or after the step
finishing. Start from this state shifts program one step forward, generally.
E.g. when we are in the step 0, after starting, the step 1 is running.
START: Active run of some step type (winding,shift,jump and pause).
STOP: State after pressing the STOP-button (cycle interruption).
Repeated start activates interrupted run and there is no step shifting.
10 / ERN C
0.00
0.00
BACK
WINDING
BACK
WINDING
TOTAL
COUNTER
TOTAL
COUNTER
CORRECTION
N. of turns
CORRECTION
N. of turns
Step :
Step :
2
2
0.0
0.0
Position:
Next step: 3- SHIFT
Name: priklad2
Position:
Next step: 3- SHIFT
Name: priklad2
1: L - L NA
1: L - L NA
2: L - L NA
2: L - L NA
3: L - L NA
3: L - L NA
4: L - L NA
4: L - L NA
PEDAL : Pedal speed value taken from program !
PEDAL : Pedal speed value taken from program !
TM
TM
WINDING
WINDING
780.00
780.00
Actual state
Step
Winding corrections
Number of turns
Wire guide position
and direction
Next step
Note
Inputs and outputs
Pedal speed
LAYER
LAYER
CANCEL
CANCEL
Step :
Step :
2
2
Turns: 780.00
L.Rev: 10.0 R.Rev: 30.0
Speed: 11965 Acc/Dec: 22
Pitch: 0.128
Cycle: Shield: CLOSE
Turns: 780.00
L.Rev: 10.0 R.Rev: 30.0
Speed: 11965 Acc/Dec: 22
Pitch: 0.128
Cycle: Shield: CLOSE
1: L - L NA
1: L - L NA
2: L - L NA
2: L - L NA
3: L - L NA
3: L - L NA
4: L - L NA
4: L - L NA
PEDAL : Pedal speed value taken from program !
PEDAL : Pedal speed value taken from program !
TM
TM
WINDING
WINDING
