If mistakes occur, these will trigger the following error messages:
ERROR Microswitch
Mechanical displacement of the wire guide. It occurs if the lateral power on the wire guide
overcomes the torque of the step motor.
Solution: press RESET
ERROR Spindle speed versus pitch
Pitch or spindle speed is too high (exceeds the max.wire guide speed 75 mm/sec)
Solution: press ENTER and correct either spindle speed or pitch
ERROR Wire guide position out of range
Winding width is out of range.
Solution: press ENTER and correct either relative position or reversal points
ERROR Program is not logical
In the ContFAST cycle type if the programming is not logical, the next step can not be the shift, jump or
winding with the opposite speed direction.
10.2 Error messages
Digital control by CAN- bus provides the storage and display of errors of Servo Drive.
Displayed errors are intended for service purposes.
58 / ERN T / V 1.3
Summary of Contents for ERN 100T
