Customize settings with TPlay
Input level
The speaker is set at the factory to self-adapt to the hi-fi system it is
connected. But it may be an advantage to preset speaker’s sensitivity, to
match the hi-fi system it is connected.
Especially with surround systems it would be good to preset the input
sensitivity of the individual speakers.
Although sensitivity is set in advance, the speaker will always regulate down if
the level is higher than it has been set.
Normally, all speakers should be set to the same sensitivity, and then fine-
tuning of the individual channels is made on the sound system.
The speaker must always be set to the nearest greater value than the output
that the sound system is provided for.
An example:
If a surround sytem data is provided to 5 * 35W, all speakers should be set to
50W. The speaker can also be connected to amplifiers with line output level,
again, select the next larger level.
Note: If the LED occasionally flashes purple, this indicates that
speaker is set at too low a level.
When this is the case, there will be distortion in the entrance, in the worst cases it can
destroy the speaker, if you play very loud.
27
