TL-WA601G
108M Wireless Access Point User Guide
2.2 The Back Panel
Figure 2-2
¾
Wireless
antenna
¾
Factory Default Reset button
¾
There are three ways to reset the AP's factory defaults:
•
Use
the
Factory Defaults
function on
System Tools
->
Factory Defaults
page in the
AP's Web-based Utility.
•
Use the Factory Default Reset button: Press and hold the default Reset button for 5
seconds, and then the AP reboot after the System led flash 5 times.
•
Use the Factory Default Reset button: First, turn off the AP's power. Second, press and
hold the default Reset button then turn on the AP's power, until the system LED lights up
(about 3 seconds). Last, release the reset button and wait for the AP to reboot.
)
Note:
Ensure the AP is powered on before it restarts completely.
¾
One LAN 10/100Mbps RJ45 port for connecting the AP to hub or switch
¾
AC power socket: Only use the power adapter provided with the TL-WA601G 108Mbps
Wireless Access Point; Usage of a different adapter may result in product damage.
2.3 System Requirements
¾
Broadband Internet Access Service (DSL/Cable/Ethernet)
¾
One DSL/Cable Modem that has an RJ45 connector
¾
A Ethernet broadband router
¾
TCP/IP protocol must be installed on each PC
¾
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later
¾
802.11g or 802.11b-compliant devices, such as the TL-WN510G Wireless Adapter
2.4 Installation Environment Requirements
¾
Not
in direct sunlight or near a heater or heating vent
4
