T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
68
gvrp timer
Description
The
gvrp timer
command is used to set a GVRP timer for the desired port. To
restore to the default setting of a GARP timer, please use
no gvrp timer
command.
Syntax
gvrp timer
{ leaveall | join | leave }
value
no gvrp timer
[leaveall | join | leave]
Parameter
leaveall | join | leave —— They are the three timers: leave All, join and leave.
Once the LeaveAll Timer is set, the port with GVRP enabled can send a
LeaveAll message after the timer times out, so that other GARP ports can
re-register all the attribute information. After that, the LeaveAll timer will start to
begin a new cycle. To guarantee the transmission of the Join messages, a
GARP port sends each Join message two times. The Join Timer is used to
define the interval between the two sending operations of each Join message.
Once the Leave Timer is set, the GARP port receiving a Leave message will
start its Leave timer, and deregister the attribute information if it does not receive
a Join message again before the timer times out.
value
——The value of the timer. The LeaveAll Timer ranges from 1000 to
30000 centiseconds and the default value is 1000 centiseconds. The Join Timer
ranges from 20 to 1000 centiseconds and the default value is 20 centiseconds.
The Leave Timer ranges from 60 to 3000 centiseconds and the default value is
60 centiseconds.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Set the GARP leaveall timer of Gigabit Ethernet port 1/0/6 as 2000 centiseconds
and restore the join timer of it to the default value:
T2700G-28TQ(config)#interface gigabitEthernet
1/0/6
T2700G-28TQ(config-if)#gvrp timer
leaveall 2000
