Toyotomi MUL12- FWCA, Service Manual

Page: 27 / 49

27
CONTROL
3.2 Wireless Remote Controller
Wireless Remote Controller YT1F
Notes:
a. Be sure that there are no obstructions between the receiver and the remote controller;
b. Do not drop or throw the remote controller;
c. Do not let any liquid into the remote controller and expose the remote controller to direct sunlight or any place
where is very hot.
d. This is a general use remote controller. If press some button which is not available for the corresponding
function, the unit will keep the original running status.
3.2.1Function of Press Buttons:
ƹ
ON/OFF ( )
Press this button to turn on/off the unit. After that, the sleep function will be canceled but the preset time is still
remained.
ƹ MODE
Auto, Cool, Dry Fan, Heat modes can be selected circularly by pressing this button. Auto mode is the default after
power on. Under Auto mode, the temperature will not be displayed. Under Heat mode, the initial value is 28 ć (82 ̧ );
Under other modes, the initial value is 25
ć
(77
̧
).
ƹ SLEEP
Sleep On and Sleep Off can be selected by pressing this button. After powered on, the default is Sleep Off. After
the unit is turned off, the Sleep function is canceled. When the sleep function is set already, the symbol will be
displayed. And at this time, the time of timer can be adjusted. Under Fan and Auto modes, this unction is not available.
ƹ
FAN
Auto, Low, Middle, or High fan speed can circularly selected by pressing this button. After powered on, the
default is Auto speed. Under Dehumidifying mode, only Low fan speed is available.
ƹ CLOCK
The clock can be set up by pressing this button, with the symbol displayed and blinking. In such a case, pressing
ˇ or ˉ within 5 seconds can adjust the value. If the button is pressed down for more than 2 seconds, the value on ten’s
place will increase by 1 in every 0.5 seconds. After that, repressing this button and then symbol stops blinking, which
indicates the setting is made successfully. After powered on, the default value is 12:00 with displayed. Once the
symbol
is displayed, the current time is the Clock value; otherwise it is the Timer value.
ƹ LIGHT
Light On and Light Off can be set by pressing this button when the unit is at On or Off status. After powered on,