© Toyota Motor Corporation Australia Ltd. 2011. All rights reserved.
REPAIR MANUAL REFERENCE
LANDCRUISER - Steel S/Cab Tray Body
ISSUE: 27/07/2012
Page
Refer to ServiceNet
Accessory Part No.: PZQ8460320
Fitting Instr. Part No.: PZQ8460320-FI
28 of 35
IMPORTANT -
Take care not to damage any components
of the vehicle
STEP
56
Install white plastic screw retainers removed from OE
tail light brackets (from step 2) into the supplied tail
light brackets (4 per bracket).
IMPORTANT -
Take care not to damage any components
of the vehicle
STEP
55
IMPORTANT -
Take care not to damage any components
of the vehicle
STEP
57
Install Tail Light Bracket to the rear of the tray body
using 2 x M6x16 bolts and M6 Nyloc nuts as shown in
the adjacent diagram.
Note:
Retro Reflector Installation applicable to Under
Body Tyre Hanger option trays only.
Locate applicable Reflector Bracket (refer to adjacent
image, and discard other reflector bracket) and fasten
Reflector Bracket to the Tail Light Protector using
M6x16 Bolt and M6 Nyloc Nut.
Ensure bracket face is parallel with Light Protector.
Carefully adhere Reflector to Reflector Bracket ensur-
ing it is square and not overhanging any portion of the
bracket.
Ensure prior to adhesion, that the surface of reflector
bracket is clean and dry.
M6x16 Bolts
+ M6 Nyloc Nut
M6x16 Bolts
+ M6 Nyloc Nut
Reflector
Bracket
Retro
Reflector
Tail Light
Bracket
FR
Remove the caps from the two wiring plugs on the
right hand side of the chassis.
Extend the vehicle wiring harness on the right hand
side of the vehicle to the registration plate lights using
the two supplied registration plate light wiring patches
(part no. 2EH04).
Zip tie the registration light wiring looms to the Under-
body Tyre Hanger bracket as shown in the adjacent
diagram.
Ensure any spare plugs (left and right hand side) have
caps fitted.
Zip tie
