Toyota 4Runner 1997, Operation Manual

Page: 105 / 221

WWW.MANUALS.WS
WWW.MANUALS.WS
111
Push “SKIP”. SKIP” will appear on the dis-
play. The cassette player will keep track of
how much blank space it plays. Any time
it has played about 10 seconds of blank
tape, it will automatically fast forward to
the next track and begin to play.
Push the button a second time to turn off
the skip feature.
ST (Stereo reception) display
Your radio automatically changes to ste-
reo reception when a stereo broadcast is
received. “ST” appears on the display. If
the signal becomes weak, the radio re-
duces the amount of channel separation
to prevent the weak signal from creating
noise. If the signal becomes extremely
weak, the radio switches from stereo to
mono reception.
TAPE
Push “TAPE” to switch from radio or com-
pact disc operation to cassette operation.
If the audio system is off, you can turn on
the cassette player by pushing “TAPE”. In
both cases, a cassette must already be
loaded in the player.
TREB (Treble)
This knob lets you adjust the treble level.
Push “TREB/FADE” so that it pops out of
its retracted position. Turn the knob to ad-
just the treble. Push the knob back into its
retracted position.
TUNE
Tuning
Your Toyota has an electronic tuning radio
(ETR). Push and release the “
∧
” (up) or
“
∨
” (down) side of “TUNE” to set up or
down the station band. (If you hear a
beep, you held the button too long and the
radio willgo into the seek mode.)
Seeking
In the seek mode, the radio finds and
plays the next station up or down the sta-
tion band.
To seek a station, push and hold the “
∧
” or
“v” side of “TUNE” until you hear a beep.
Do this again to find another station.
The anti-theft system prevents the audio
system from working after it has been dis-
connected. To activate the system, you
must set a three-digit security code. After
the system is set, “SEC” will appear in the
display each time the ignition is turned
form “LOCK” to “ACC” or “ON”. Also, the
anti-theft light flashes every few seconds
while the ignition key is in the “LOCK”
position.
You will need to know your security code
to reactivate your radio after electrical ser-
vice is performed on your vehicle.
Choose a security code that is easy to re-
member and keep a copy of it (not in your
Toyota).
NOTICE
If you pushed any wrong buttons on
the anti-theft system, the following
messages will appear on the
display.
“Err”—You have pushed wrong
buttons.
—Anti-theft system
(Type 2-2 and 3 only)