Toyota 2000 Tundra, Owner'S Manual

Page: 104 / 250

TUNDRA (34413U)
102
“N” (neutral position): Lever at “N”
No power is delivered to the wheels. The
vehicle must be stopped.
“L4” (low speed position, four- wheel
drive):
Lever at “L4”
Use this for maximum power and traction.
Use “L4” for climbing or descending steep
hills, off- road driving, and hard pulling in
sand, mud or deep snow.
The “4WD” (four- wheel drive) indicator
light comes on when the “H4”, “N” or “L4”
mode is selected.
See “(c) Shifting procedure (lever type)”
for further instructions.
Use the “2WD/4HI” and “4LO” buttons
to select the following transfer modes.
1. “2WD” (high speed position, two-
wheel drive): “2WD/4HI” and “4LO”
buttons left out
Use this for normal driving on dry,
hard- surfaced
roads. This position
gives greater economy, the quietest
ride and least wear.
2. “4HI” (high speed position, four-
wheel drive): “2WD/4HI” button pushed
in
The “4HI”
(high speed four- wheel
drive) indicator light comes on when
the “4HI” mode is selected.
Use this for normal driving on wet, icy
or snow- covered roads. This position
provides greater traction than two-
wheel drive.
3. “4LO” (low speed position, four-
wheel drive): With the “2WD/4HI”
button pressed in, push the “4LO”
button
The “4LO” (low speed four- wheel drive)
indicator light comes on when the
“4LO” mode is selected.
Use this for maximum power and trac-
tion. Use “4LO” mode for climbing or
descending steep hills, off- road driving,
and hard pulling in sand, mud or deep
snow.
(a) Front drive control
(button type)