Toyota 1991 CAMRY Body Section, Repair Manual

Page: 37 / 111

mm
in.
mm
in.
15
624
744
869 0.59
24.57
29.29
34.21 1,111
1,320
1,392 43.74
51.97
54.80
INSTALLATION
Butt Weld
Wet Rag
Preparation for Supply Parts
Outer Pillar
Cutting Location
Butt Weld
about
15 mm
Wet Rag
w/o
Automatic
Shoulder
Belt
Braze
(front side and rear side)
w/o
Automatic
Shoulder
Belt
w/ Automatic
Shoulder Belt
w/ Automatic
Shoulder Belt
w/ Automatic Shoulder Belt w/o Automatic Shoulder Belt
Upper Reinforcement
Upper Inner
Pillar
Upper Inner
Pillar
[REFERENCE]
Door Lock Striker
Plate Retainer
NOTE: Before performing these operations,
place a wet rag on the roof panel to protect it
from damage.
3. Braze the roof side outer rail and center pillar
connection.
NOTE: Smooth down the surface.
Rail leakage will occur if the weather strip con-
tact is defective.
[Preparation for supply parts]
1.
After installing the upper reinforcement to the
outer pillar, cut them at the location as shown
above.
[Installation]
1. After temporarily installing the new part, check
fit for the front and rear door.
2. After butt welding the new joint with a MIG
welder, sand the weld joint with a sander.
BODY PANEL REPLACEMENT RE-19