8
GB
O
R
I
G
I
N
A
L
I
N
S
T
R
U
C
T
I
O
N
S
SUMMARY OF THE PRODUCT
Ash vacuum cleaner is used for cleaning fi replaces, grill bowls of cold, dry ash. Due to large tank and to fl exible hose it is pos-
sible to access the hard to reach places and clean them thoroughly. The vacuum cleaner is equipped with a replaceable air fi lter.
The product is not intended for commercial use. Correct, reliable, and safe operation of the tool is dependent on proper use,
therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damage or injuries caused by failure to comply with safety regulations and instructions of this manual, the supplier is not
responsible.
PRODUCT EQUIPMENT
The product is supplied in a complete state and requires no assembly. Along with the product, there is delivered the hose and
aluminum suction nozzle.
TECHNICAL DATA
Parameter
Unit
Value
Catalogue No
72928
Mains voltage
[V~]
220 - 240
Mains frequency
[Hz]
50 / 60
Rated power
[W]
800
Hose length
[cm]
100
Length of the suction nozzle
[cm]
23
Tank capacity
[l]
18
Insulation class
II
Degree of protection
IPX0
Weight
[kg]
2.5
GENERAL SAFETY CONDITIONS
The device can be used by children at age of 8 years and older and persons with reduced physical, sensory, or mental abilities,
also by people with lack of experience and knowledge, if there is exercised supervision over them, and if there have been com-
municated to them instructions for safe use and they understand the risks.
You should supervise the children to not play with the appliance. Cleaning and maintenance should not be performed by children
without supervision.
The vacuum cleaner is designed for dry operation. It is forbidden to suck water, wet ash or other wet waste. This may cause an
electric shock, which in result may pose a threat to the health and life for the user and bystanders.
Never suck hot, glowing or fl aming objects. This can cause a fi re or explosion, and expose you to serious injury or death. The
maximum temperature of sucked impurities must not exceed 40 °C.
The device is designed to work indoors and should not be exposed for water, including the rain.
Before connecting the power cord plug of device, make sure that the parameters of the mains correspond to the parameters
visible on the nameplate.
Before each use, check the device status, including the state of power cord and plug. If you notice any faults, do not use the
device. Damaged cables and wires must be replaced with new ones in a specialized workshop.
Prior to the maintenance of the equipment, make sure that the power cord has been disconnected from the mains socket.
The device should be stored out of reach for bystanders, especially children. Also during the operation a special care should be
taken that the device was in a place inaccessible to unauthorized persons, especially children.
Transfer device with a handle, do not move it by pulling the cord.
If you use a vacuum cleaner as a blower socket it is prohibited directing the hose at people or animals.
You should regularly check the condition of the hose. It is forbidden to use a vacuum cleaner with a damaged hose.
OPERATION OF THE DEVICE
Preparing for operation
Check the vacuum container, if it is necessary empty the waste.
Check the condition of the fi lter, in the case of soiling clean it with a jet of compressed air, of pressure of not more than 0.3 MPa.
If dirt cannot be removed from the fi lter, replace it with a new one. Check the gasket integrated with the upper edge of the fi lter, if
the fi lter shows damage, it must be replaced for a new one.
