YW1838
3
Factory Default Settings
Master Code: 12345
Passage Mode: Disabled
Pass Time: 5 seconds
Sound: Enabled
Lock Status Indicator: Disabled
Penalty Time (Keypad Anti-Tamper Lockout Time): 60 seconds after 3 Invalid Code Entries
Important Notes
•
Factory Default Settings Master Code must be changed before programming any other codes.
•
Manufacturer assumes no liability, direct or indirect, due to failure to change Master Code.
•
Pressing the Star (
✴
)
key will cancel any on-going program sequence or code input.
•
Pressing the Pound (#) key starts programming.
•
Programming can be done only if the lock is locked.
•
Replacing batteries does not change existing settings.
•
During programming, green LED indicator indicates success and the red LED indicator indicates failure.
o
One green LED flash and 2 short beeps occurs after each
program sequence. (●)
o
Two green LED flashes and 2 beeps (one short beep and one long beep) occurs at the end of each successful
program sequence (●●).
o
One red LED flash and 1 long beep indicates failure program sequence.
•
The red LED will flash 0.5 second (with one long beep) after an invalid code is entered.
•
It is important to maintain track of user ID’s and Codes used in the system to use certain features.
Disclaimer - The codes used in the following examples are not recommended for actual valid codes. Accepted protocol should be
followed for secure codes. Repeated strings of numbers are not secure.
Summary of Contents for e-Smart 2000 Series
Page 1: ...YW1838 0 ...
Page 12: ...YW1838 11 ...