Continuous Pilot/Intermittent Pilot (CPI/IPI) selection
With the system in "OFF" position press the Mode Key (fig. 5
9
) to index to the CPI/IPI
mode icon (fig. 6
9
&
70
).
Pressing the Up Arrow Key will activate the Continuous Pilot Ignition mode
(CPI). Pressing the Down Arrow Key will return to IPI. A single “beep” will
confirm the reception of the command.
NOTE: If the system is equipped with a CPI/IPI toggle switch:
•
Set the CPI/IPI switch to CPI position (switch closed) to enable
remote CPI/IPI operation.
•
Set the CPI/IPI switch to IPI position (switch open) to disable
remote CPI/IPI operation. The system will now work in IPI mode
only regardless of the selection on the remote control hand set.
KEY LOCK
This function will lock the keys to avoid
unsupervised operation.
To activate this
function, press the MODE and UP Keys at
the same time, a lock symbol will appear
(fig. 7
1
).
To de-activate this function, press
the MODE and UP Keys at the same time
.
Fig. 7
1
LOW BATTERY POWER DETECTION
Transmitter
The life span of the remote control batteries
depends on various factors: quality of the
batteries used, the number of ignitions of the
appliance, the number of changes to the room
thermostat set point, etc.
When the Transmitter batteries are low, a
Battery Icon will appear on the LCD display of
the Transmitter (Fig. 7
2
) before all battery
power is lost. When the batteries are
replaced this Icon will disappear.
Fig. 6
9
Fig.
70
Fig. 7
2
39
TCWS38_D 011214-48
Summary of Contents for TCWS38
Page 43: ...Fig 76 Wiring Diagram 43 TCWS38_D 011214 48 ...
Page 45: ...45 TCWS38_D 011214 48 ...
Page 46: ...46 TCWS38_D 011214 48 ...
Page 47: ......
