Fig #24
11.
Pull off the rubber cap from the top of
the pressure regulator.
(Fig.
#21)
12.
Press down on the center post and rotate
90°. The center post should stay down.
(Fig. #22). Replace the rubber cap.
13.
Fill in the date and the name of the
person who performed the conversion
in the white area on the conversion
label. Peel off the protective backing
and apply the conversion label directly
over the gas specifi cations on the rating
label.
13. Re locate the control box shield and
re-attach the access panel to the side
of the fi rebox with the screws
previously removed. (Fig. #23 & 24)
Note: Both the control box shield and the
access panel must be reinstalled after
conversion/ installation or servicing has
been completed. Failure to do so may
cause premature failure of the control
system.
Fig #21
Fig #22
Fig #23
NG
LP
8
TCWS.54NG04.C 040907
