Owners Information
The Heli-Fire installation and venting must conform to the current CAN/CGA-B149 installation code (in
Canada) or the current National Fuel Gs Code, ANSI Z223.1 (in the USA), and approved per local codes.
Only qualified (licensed or trained) personnel should install this product.
In the state of Massachusetts, only a licensed Plumber and Gas Fitter may install this product.
In some jurisdictions, the Heli-Fire may be installed in Manufactured Homes after the “first sale”. Consult
local codes for approval. The Heater must be fastened in place.
Install in accordance with the current standard Mobile Homes, CAN/CSA Z240 MH (in CANADA), and the
Manufacturer’s Home Construction and Safety Standard, Title 24 CFR, Part 3280 or the current Standard
for Fire Safety Criteria for Manufactured Home Installations, Sites and Communities ANSI/NFPA 501A (in the
USA).
Warning: Turn off the Heli-Fire, and allow ample time for the unit to cool before proceeding.
Caution: The tempered glass is very fragile, and should be handled with care.
The Heli-Fire door comes with a silicone seal and metal frame pre-assembled for easy mounting.
To replace a damaged door:
1. Remove the decorative trim from its magnetic holder.
2. Remove all 18 bolts from the door frame using the provided 5/32 Allen key. Be aware that the last bolt to
come out will allow the door frame to fall and keeping control of the door frame is crucial at this point.
3. Remove broken glass (if any) from the inside of the Heli-Fire.
4. Carefully position the replacement door frame against the Heli-Fire and align the bolt holes.
5. Insert one bolt and then a second bolt on the opposite side of the frame in order to stabilize the frame.
Tighten them only finger tight at this point.
6. Insert the remaining bolts into the door frame. Tighten them only finger tight at this point.
7. Using the provided 5/32 Allen key (do not use a power driver), tighten the bolts so that the door frame sili-
cone seal is slightly compressed against the Heli-Fire (about 1 1/2 turns past finger tight). Visually inspect
the door frame upon completion.
8. Return the decorative trim to its place on the Heli-Fire.
7
5055.64-A
TCHF.22BODYA_ 211215-32
TCHF.22STBODYA
Installation Requirements
Manufactured (Mobile) Homes
Door Frame Removal/Installation
