5056.42562
Figure 48: Panel brackets.
Figure 50: Retainer panel
screws location.
Figure 49: Side retainer.
PARK AVE. BEIGE HERRING BONE2 ............................... TCPN.54PAC2
MOUNT VERNON RED BRICK2 ........................................ TCPN.54VRC2
MANHATTAN STACKED BRICK2 .................................... .TCPN.54MNC2
BLACK PORCELAIN ..............................................................TCPN.774.C
COFFEE BEAN BROWN PORCELAIN .............................TCPN.774CB.C
COPPER PORCELAIN ......................................................... TCPN.774CU
TITANIUM PORCELAIN ......................................................... TCPN.774TI
(See Porcelain panel instruction manual for specific instructions for these panels)
The lower rear panel is held tight
against the side panels by two "V"
brackets located on the firebox
rear wall. Although the brackets are
adjusted at the factory for the best fit,
some adjustment may be necessary.
Adjust the angle of the bracket by
hand to ensure a snug fit.
A Firebox Panel Set must be installed for safe operation. Do not use the fire-
place without panels. Unpack and inspect all panels. The panels need to be
installed before the logs are in place.
Caution:
The Firebox Panels are very fragile, and should be handled with care.
1. Remove the Side Panel Retainer (Figure 49) located on the underside of the
firebox heat shield. The retainer slips between the lip of the firebox and the
heat shield and is retained in place by two screws (Figure 50).
2. Install the Lower Rear Panel
REAR LOWER PANEL
ADJUSTABLE “V” BRACKET
SIDE PANEL RETAINER
HEAT SHIELD
FIREBOX LIP
SCREWS
29
TC54D _111215-44
Firebox Panels Installation
TC54 PANELS
