5056.426D2-A
4
TC42_NG06D_060117-16
6. Attach the ignition and sensor
wires to the module (Figure 7).
7. Replace the access cover
(Figure 4: Control center
access cover. on page 2)
8. Position the slots of the grate
securing brackets over the holes
in the floor shield and secure
with the two screws (Figure 8).
Ignition wire (red)
Flame sensor
wire (white)
Interface module
Figure 7: Interface module.
Figure 8: Securing the grate.
A panel set must now be installed.
See Installation and Operating
Instructions manual for details.
