22
❏
10. If you’ve mounted an electric motor with the adjustable
brushless motor mount, move the motor forward the distance
of the desired spinner gap. Test-mount the cowl to the
fuselage with four M2.6 x 8 washer-head wood screws.
❏
11. If you’ve mounted a glow
engine, use a Dremel 569 and/
or 570 Dremel
grout removal
bit
and a sanding drum to cut
holes in the cowl for the glow
plug igniter, muffler, needle
valve and fueling/defueling line.
Caution:
Be certain to wear
eye and respiratory protection
when cutting fi berglass.
Finish the Radio Installation
Mount the receiver battery and on/off switch (if used) and the
receiver where practical and convenient. Review the following
steps to see the options. An optional
universal mounting
tray
is included for the receiver and/or receiver battery and
another optional
battery tray
is also included to mount a
receiver battery in the nose. If you’ve installed an electric
motor, the receiver should be mounted on the
bottom
of
the servo tray in the wing saddle so as not to interfere with
installation/removal of the battery tray.
❏
1. If not using the universal mounting tray, use double-
sided foam adhesive tape or adhesive-back Velcro to mount
the receiver where desired. Use tape to hold the receiver
antennas perpendicular to each other as specifi ed in the
instructions that came with your radio control system.
❏
2. If using the optional
universal mounting tray
, glue
the ½" x ½" x ¼" [13 x 13 x 6mm] hardwood
tray mount
blocks
into position where shown. Fit the tray and drill
1/16" [1.6mm] holes and mount the tray with four M2.3 x 8
washer-head screws.