Tower Hobbies T10023, Safety And Instruction Manual

Page: 9 / 15

9
Note: You can stop the boil process at any time by pushing the On/Off switch up to the
off position.
9. If you need to boil the kettle again, wait for a few seconds - allow the ON/OFF switch
time to reset.
10. When you lift the kettle up, you may see drops of water on the base. This is just
condensation from steam.
11. To avoid splashing or spilling, pour the kettle slowly and do not over-tilt it.
WARNING! NEVER REMOVE THE LID DURING BOILING
Tips: Improve the quality of your drinks by always using fresh water.
Empty the kettle after each use.
Be economical and do not boil more water than you need.
Boil Dry Protection:
• Your kettle will switch off automatically if you try to use it with too little water or if it
is empty.
• If this happens, ensure the On/Off switch is in the off position, remove it from the
base unit and allow it to cool down before re-filling.
• Wait at least 15 minutes for the cut-out to reset before refilling with cold water and
boiling.
Note: Do not switch the kettle on unless it contains at least one cup of water. Misuse of
this kind can shorten the lifespan of the kettle.
Filter:
• Your kettle is fitted with a filter. The filter helps to prevent lime-scale from getting
into your drink.
• The filter should be cleaned regularly, in particular if there are noticeable deposits
left on it, or if pouring is affected in anyway.
• To clean the filter, rinse it under the tap.
6 - Troubleshooting
Questions Answers
Water is coming out of
the spout of the kettle. 1.
2.
Only fill the kettle to the max fill line.
Ensure you wait 10 seconds for the boiling water to settle before
pouring.