8
Using Your Kettle
• Fill the kettle using either the spout or lid.
• The water level must be between the MAX and MIN fill lines.
• Check that the lid is closed correctly.
• Ensure that the base unit and the base of your kettle are not wet.
• Place the kettle onto the base unit and plug in.
• Switch the kettle on by pushing the On/Off switch to the ‘On’ position.
• Your kettle will begin to boil and will switch off automatically when it is done.
The On/Off switch will automatically move into the ‘Off’ position when done.
• The kettle can be switched off manually by putting the On/Off switch to ‘Off’.
• If you need to boil the kettle again, wait for a few seconds - allow the On/Off
switch time to reset.
• When you lift the kettle up from the base, you may see drops of water on the
base. This is just condensation from steam.
• To avoid splashing or spilling, pour the kettle slowly and do not over-tilt it.
ATTENTION: Improve the quality of your drinks by always using fresh water.
Empty the kettle after each use. Be economical and do not boil more water than
you need.
Boil Dry Protection
• Your kettle will switch off automatically if you try to use it with too little water.
• If this happens, ensure the On/Off switch is in the off position, remove it
from the base unit and allow it to cool down before re-filling.
Washable Filter
• Your kettle is fitted with a filter. The filter helps to prevent lime-scale from
getting into your drink.
• The filter should be cleaned regularly, in particular if there are noticeable
deposits left on it, or if pouring is affected in anyway.
• To clean the filter, remove it from the kettle and rinse it under the tap. You
can also drop the filter in when de-scaling your kettle.
• Rinse the filter thoroughly before fitting it back into the kettle.
