7
BUILD THE WING
❏
2. Test fi t a CA hinge into each of the hinge slots in the wing
and ailerons. If necessary, enlarge the slots with a hobby knife.
When satisfi ed with the fi t, insert a CA hinge halfway into each
hinge slot in the wing panel. Push a pin through the middle of
each hinge to keep them centered.
❏
3. Join the ailerons to the wing and remove the pins from
the hinges. Align the tips of the ailerons with the wing tips.
Adjust the ailerons so there is a small gap between the LE of the
ailerons and the wing. The gap should be small, just enough to
see light through the gap or to slip a piece of paper through.
❏
4. Apply six drops of thin CA to the top and bottom of
each hinge without using accelerator. After the CA glue has
hardened, confi rm that the ailerons are secure by pulling on
them and defl ecting them up and down.
INSTALL THE AILERON SERVOS
AND PUSHRODS
❏
1. Attach a 12" [305mm] servo extension to each aileron
servo. Secure the connections using tape, heat shrink tubing
(not included) or special clips designed for that purpose.
❏
2. Locate the strings taped inside the aileron servo bays and
tie the ends of the strings to the servo extensions. With the string
ends securely tied to the extensions, use needle nose pliers to
retrieve the center of the string from the servo lead exit hole in
the center of the top of the wing. Use the string to pull the servo
leads through the wing ribs and out the servo lead exit hole.
