TOURNUS EQUIPEMENT 806 301, Technical And User Manual, Page: 16 / 32

3 USE
TECHNICAL MANUAL – TS 2000 N WASH BASIN
ENGLISH
16
25 avenue Jean Moulin
B.P. 59 71700 TOURNUS - FRANCE Tél. +33 (0)3 85 27 42 42
Fax. +33 (0)3 85 27 42 99
104003 Iss.12
SEE PRESTO ELECTRONIC TAP INSTRUCTION MANUAL ATTACHED.
NB:For soap dispensers : only use liquid soap.
4 CLEANING / MAINTENANCE
4.1 Instructions
In order to maintain the finish of the stainless steel as much as possible and avoid oxidation, you are strongly advised to clean the appliance regularly.
• Wear suitable gloves during these cleaning operations.
Products to be avoided at all costs:
• Do not use floor cleaning products, acids, even diluted, chlorinated or stripping products which could corrode the stainless steel.
• Do not use abrasive products (steel wool, etc).
Recommended cleaning products:
- All bleach-free detergents (powder detergent, alkaline detergents and liquid soaps).
- Degreasing agents for glazed parts.
- Water (hot or cold).
”Renovation” cleaning :
If the stainless steel becomes dull, stained or rusty from chlorine products or there is a lot of scale built up, use a strong acid based product, for instance
phosphoric acid or nitric acid.
TOURNUS EQUIPEMENT proposes a passivation product (
reference 284 500 ). Apply the product to the areas that are altered, allow to react for 15
minutes and rinse thoroughly with water. Always rub in the original brushed direction.
5 FAULTFINDING
6 GUARANTEE
• The guarantee only applies to normal use in strict compliance with the recommendations shown in our technical and user manuals.
• In order to benefit from our guarantee, our appliance must not undergo any alteration or repair made with non-original parts and not approved by our
departments.
Description of problem Checks to be performed
" the tap keeps running ”: there is a constant trickle of water or dripping.
The solenoid valve is probably soiled:
1- Take out the solenoid valve and clean it.
2- Make sure the filter baskets are fitted.
3- If the problem persists, change the solenoid valve.
4- The detection cell is covered with dry soap, scale, etc. - clean it.