TOURNUS EQUIPEMENT 806 301, Technical And User Manual, Page: 14 / 32

2.1 Unpacking
Before unpacking the appliance, check that its packaging and any protective elements are not damaged in any way.
If there is any sign of damage, it is the buyer’s responsibility to claim against the carrier within the statutory time limits.
Under no circumstances can a damaged appliance be returned to the manufacturer without notice and without its prior written consent.
Unpack the appliance and put it in the place it is to be sited.
2.2 Setting up
- The product guarantee is conditional on compliance with these rules.
FITTING AND USING .
• For products delivered with filters, these must be fitted in accordance with the instructions. Before using our taps, whatever the type, it is essential to
drain the piping carefully . Recommended working pressure as per MF EN 816: 1 to 5 bar.
CLEANING.
• The chromium-plated coating for PRESTO taps must be cleaned with soapy water only.
• Do not clean with abrasive, acid, alkaline or ammonia products.
support
2 INSTALLATION
TECHNICAL MANUAL – TS 2000 N WASH BASIN
ENGLISH
14
25 avenue Jean Moulin
B.P. 59 71700 TOURNUS - FRANCE Tél. +33 (0)3 85 27 42 42
Fax. +33 (0)3 85 27 42 99
104003 Iss.12
STEP 1:
• Fix the wall bracket with 3 screws Ø6 (not supplied) to the desired height.
Use this as a template for drilling.
• Drill a hole for screw M6 (not supplied) which will allow for the splash
back to be sufficiently held to the wall.
NB: Mains supply model.
• Main supply connection 230V AC with 2 x 0,5 mm² cable mini (Diameter 6
à 8,5 mm). Line protection with a circuit breaker 30 mA and with an
omnipolar cut off device (switch or circuit breaker) with an opening
distance of contacts of at least 3 mm.
STEP 2:
• Put the tap throught the hole on the bowl and lock it.
STEP 3:
• Install the wash basin by hooking it
onto the wall bracket bar. (if
necessary, add fixing screws to the
lower part of the rear splash back of
the wash basin).
• Fit the spacer with shoulder and
tighten the splash back against the
wall with a screw M6 (not supplied).
• Stick the (self-adhesive) sticker over
the fixing screw to hide it.
• You have to make a silicone seal
arround the back upstand.
•Area where cold or hot water connection must be
integrated.
• 3 holes for extra screws if
necessary.