Toua GFN3490CH, Safety Operating Manual

Page: 17 / 24

15
(4) Remove the jam nail.
(5) Tighten up the bolt with wrench.
(6) Reconnect the Cylinder Head Assembly ,
Spark Cap and Motor Wire Plug , tighten
up all bolt with wrench.
USING THE HOOK
CAUTION
Using the hook, can hang on the nailer to the work
belt or scaffolding on work.
This nailer hook can left and right side by side mounting
Fig (a) and Fig (b).
If need, can according to the following steps exchange
(1) Use accessory wrench (M5) loosen and pull out
two screws.
(2) Pull out the hook, reversal insert.
(3) Insert the screws and tightening.
The screws must make sure be tightening to avoid
the hook fall off cause to the nailer damage or hurt
someone.
If the tool falls, there is a risk that malfunctions or
parts damage can occur.
It is recommended that you also use fall- preventing
wires, etc.
,
：
MAINTENANCE
NOTE:
■ The information contained in this Manual is designed
to assist you in the safe maintenance of the Nailer.
■ Some illustrations in this Manual may show details
or attachments that differ from those on your own
Nailer.
MAINTENANCE AND INSPECTION
Read section titled “SAFETY”.
DANGER
■ Never use and test in presence
of flammable liquids or gases.
■ Keep away from ignition source.
■ No smoking.
WARNING
Remove fuel cell, battery and all nails from Nailer
when:
Daily cleaning;
Maintenance and Inspection;
Clearing a jam.
1. Daily cleaning
Must regularly to clean nailer, remove the internal
accumulation of smeary, carbon and dust, and to
ensure the normal operate, extend nailer working
life. Please use appointed designated cleaner
(504.6.04.001.01).
Follow the attachment Gas Framing Nailer
Cleaning Reference Guide and Cleaning Re-
ference Guide to clean the nailer.
The nailer cleaning intervals depends on the
nailer operating environment and the firing quantity
per week of nails. If using at the dirty environmental
and firing large quantity per week, nailer cleaning
intervals will be shorter.
Below is the cleaning time intervals form for you
reference. If you according to the cleaning time
intervals form to clean the nailer find the nailer is
extremely dirty, the cleaning time intervals should
be shorten, conversely, if find ther nailer is very
clean, extend cleaning time intervals.
Fig (a) Fig (b)
jam nail