TSP Series Quick Start Guide
13
3.2.4
Final Assembly
Tenon Door – Reseat the hinge and gently close the tenon door and secure in position
with the two captive thumbscrews.
You must remove the fuselage endcap to install the light wings.
The light distribution pattern can be adjusted by altering which fuselage grooves are
selected when seating the wings.
The wings slide into the fuselage
in a fixed groove on the sides of
the fuselage. The top grooves
are numbered 1 through 6 with
number 6 being closest to the
fuselage on both sides. Both
wings should utilize the same
groove to ensure even coverage.
Select the proper groove
according to the desired light
distribution as shown in the
following table:
Slot Number
Wing Angle
(degrees)
1
0
o
2
4.5
o
3
9
o
4
13.5
o
5
18
o
6
22.5
o
For more information on light distribution, see the user manual.
Slide each wing into the fuselage as desired for proper light distribution, taking care to
avoid damage to the LED power cable. Ensure that both wings utilize the same
numbered slot.
Position the weather seal grommets and press firmly to fully
seat them in their notches. The outer edge should be flush
with the edge of the main housing. This is important to
maintain proper weather seal.
If the Lighting Control Module (LCM) becomes detached,
slide it into position and verify that the two LED light panel
power cables are firmly connected. The Right Wing connector
is the upper connector, the Left wing connector is the Lower connector.
When properly seated the Lighting Control Module (LCM) handle should be flush with
the outside edge of the main housing.
Re-install the endcap and its gasket and tighten the four fasteners evenly.
Factory Default
