7
-1
.
Adjustment after installation
1. Check of water flow
3. Check the discharged water temperature
2. Clean the filter and cap of the water discharge port.
Spout side
Shower side
"40"
Temperature
control handle
Safety button
Upper (Shower side)
(Open/Close)
changeover
handle
About 40 °C
Mounting leg
Spout
Flat-head
screwdriver
Loosen
Water
discharge
port
Packing
Spout
Cap of discharged
water port
Round-plate-like
object
Water faucet body
Filter
Mounting leg
After the completion of mounting, open
the main valve of the pipes and check if
water comes out from the spout and the
shower.
If the filter and the discharged water cap are clogged, the flow rate
decreases or only cold water or scalding hot water comes out. Thus, the
product will not be able to exert the sufficient performance.
Please explain to the customer to clean the product from time to time.
*When cleaning the filter, close the main valve surely and dismount the filter.
In addition, make sure that the left side of the main unit body and the mounting
legs of the hot water side are not hot.
(For details, please refer to "Daily Care" in the instruction manual.)
*When removing the discharged water cap, do not use a thin-tipped tool such as a
flat-blade screwdriver, etc.
The temperature control handle is set at the factory, but the water
discharge temperature may not be as displayed due to the conditions of
use (cold/hot water supply pressure and temperature).
Check the temperature as follows.
1. Set the safety button of the
temperature control handle
to “40” on the scale of the
main unit.
2. Turn the (open/close)
changeover handle up to the
upper limit.
Water comes out from the shower.
3. Check the water discharge
temperature.
If the water discharge temperature is
about 40 °C, use the product as it is.
If the temperature is low, raise the
set temperature of the hot water
supplier until 40 °C hot water comes
out.
To prevent scalding, set the hot
water supply temperature of the hot
water supplier to a temperature not
exceeding 60 °C
．
Even if the temperature of the hot
water supplier at higher than 50 °C,
the handle setting is necessary if the
temperature is low.
When finished mounting the product, be sure to clean the filter and the
cap of the water discharge port.
