29
For models with a bath spout
8. Match the resin plate to the base, fix it with four screws and attach the
plate.
For the attachment screws, tighten them until the seal material on the
resin plate collapses (the gap between the resin plate and the wall
disappears).
Push in the plate until the gap between the plate and the wall is less
than 1 mm.
After attaching the plate remove the curing material.
9. Match the switching (open/close) handle lever and the "
" of the
plate and insert them all the way in.
10. For the switching (open/close) handle lever, use an hexagonal bar
wrench to tighten the stopper screws.
11. Set the safety button of the temperature regulating handle to match
the "40" mark on the plate and push it in.
12. Fix the machine screws and push in the cap.
13. After fixing check that hot water at the appropriate temperature
(approximately 40°C) comes out.
EN
Model TBP02001
1. Loosen the screws (4) and remove the spout cap.
Avoid losing the screws.
2. Remove any garbage and dirt stuck in the filter and straightening plate
with a toothbrush or the like.
3. Attach the filter, straightening plate and the spout cap.
Summary of Contents for TBV02403
