STEP
3-B
Mount the water inlet bracket on the wall
STEP
3 -B
-
STEP 6
-
Connect the water supply lines to the water inlet bracket.
STEP
4
Connect the controller to the water inlet bracket
-
Connect the controller to the water
inlet bracket.
-
Attach it with a quick fastener.
Flexible hose
Copper tube
Flexible hose
Nut
Packing
not included
Copper tube
Nut
Friction ring
Cone washer
not included
Quick fastener
Water inlet bracket
Controller
STEP 5
Cut the spout connecting hose if necessary
-
Cut the spout connecting hose to
the appropriate length.
If the spout connecting hose is
too long, cut it to proper length.
Do not cut the hose more than
4 inches.
Be sure to cut the hose carefully
with a cutter, so the surface
is square.
-
Insert the spout connecting hose
into the flexible tube.
Clean the hose
end after cutting.
Spout connecting
hose
Cutting length:
4 inches or less
90
゜
Spout connecting
hose
Flexible tube
¤
Remove the Permanent Flow Valve
Pull out the pinch of the stop ring,
then remove the permanent
flow valve
Remove
Permanent Flow Valve
Stop Ring
Pull out
this pinch
STEP 6
Connect the spout connecting hose to the controller
-
Insert the spout connecting hose
into the controller.
-
Fasten the hose with the hose
clamp.
●Check that the spout connection
hose is firmly in place.
●Do not bend the spout connection
hose.
●
The hose clamp should be attached
at the specified position.
●The spout connection hose must be
fastened with the hose clamp.
Spout connecting
hose
Hose
Clamp
Fit the hose clamp over the hose adaptor.
Caution