11
10
Remote Controller
Front
Back
Before Using the NEOREST 600
Introduction
2 AA batteries
Battery cover
Open
Close
Wall Hanger
Preparations
Insert batteries into the remote controller.
➀
Remove the remote control from the wall hanger.
●
Grasp the sides of the remote with both hands
and lift straight up.
➁
Remove the battery cover on the back of the remote controller.
➂
Insert 2 AA batteries
➃
Replace battery cover.
●
If the batteries have been installed correctly,
the display on the back of the remote should
look like the following illustration.
1
●
Please observe the following to keep batteries from rupturing or leaking.
●
Always use new versions of the same battery type.
●
Remove the batteries when not using the unit for a long period of time.
●
Do not use rechargeable batteries.
●
Time to replace batteries.
As the batteries wear down, the dead battery indicator light on the remote
controler will begin blinking. Change the batteries at that time.
Batteries
1
●
Turn the main Neorest unit to "OFF" when changing batteries or doing maintainance.
●
When changing the batteries, some features such as the "Timer Energy Saver" function may be switched
off. Reapply your settings after completion.
●
When changing the batteries, the "Dead Battery" light may glow for approximately 2 seconds. This is
normal.
Pulsating Wash On/Off Button
Oscillating Wash On/Off Button
(See Page 13)
Remote Control Flush Button
(See Page 20)
Dead Battery Warning LED
(See Page 11)
Remote Control
Transmitter
Stop Button
(See Page 13,14)
Rear Wash Button
Soft Wash Button
Front Wash Button
(See Page 13)
Water Pressure Adjustment Button
Wash Position Adjustment Button
(See Page 13)
Remote Control
Transmitter
Remote Toliet Seat/Lid Open/Close Buttons
(See Page 17)
Dryer Button (See Page 14)
Remote Control Display
Toilet Bowl Clean Button
Wand Cleaning Button
(See Page 36)
(See Page 37)
Automatic Mode
Auto Flush On/OFF (See Page 21)
Auto Lid Open/Close (See Page 17)
✲
The default for the auto settings is ON.
Energy Savers
Timer Energy Saver Button
Automatic Energy Saver Button
(See Page 25-27)
(See Page 23, 24)
Seat Temperature Button
Water Temperature Button
Dryer Temperature Button
Cleaning Mode
Temperature Settings
(See Page 15)
Temperature Adjusting
Buttons
Unit beeps when main unit receives a signal from the remote control.
Remote Control
Display
Loosen the screws on the anti-theft mounts and remove the remote
controller. When returning, remember to fully tighten the screws.
*Use a small philips head screwdriver
*Do not over tighten the screws as this may damage the remote
controller.
(1) Loosen the mounting
screws with a philips
head screwdriver (one
mount on left and right
of remote).
(2) Remove remote
controller from hanger.
Anti-theft
blocks
mounting
Wall
Remote
Hanger
Wall
Screwdriver
Screw
Remote
Hanger
Anti-theft
mounts
Blinks
If you are using the anti-theft mounts