33
32
Reattach the toilet seat
●
Grasp the toilet seat with both hands, making
sure to keep the black line on the seat cord
straight.
●
Insert the toilet seat straight into the seat pins.
●
Lower the toilet seat.
✲
Be careful not to get the seat cord twisted when
installing the toilet seat.
✲
Do not install the seat at an angle or use force
when pushing down on it.
L
Approximately
90˚ angle
Black line:
keep this line
straight when
installing the
toilet seat.
Reattach the lid
●
Grasp the lid with both hands and insert straight
down into the toilet seat pins.
●
Lower the lid.
✲
Do not install the lid at an angle or use force
when pushing down on it.
Approximately
90˚ angle
If the toilet seat pins come out:
Left
Right
R
L
1.
Check the toilet seat pin tips for "right" and "left" markings
to ensure proper installation.
2.
Insert the right and left pins all the way into
the respective slots.
✲
Do not apply force when
pushing the
pins into the slots.
Toilet seat
pin (left)
L
Cleaning crevices between the main unit and the toilet bowl.
(Perform once a week.)
Clean the crevices with a small
brush.
●
Perform routine cleaning of the crevices to prevent water and dirt from getting into the seal.
Protective
Seal
Brush
Neorest 600
main unit
Toilet bowl
Protective Seal
Maintenance
Cleaning the deodorizer filter.
(Filter should be cleaned once a month.)
Remove the deodorizer filter.
●
Pull the filter (gray) forward.
●
Follow the steps below to remove dust from the filter.
Filter
Clean the deodorizer filter
●
Brush the dust off of the filter surface with a
small brush, such as a toothbrush.
Reinstall the deodorizer filter
1
1
Cleaning the filter
●
When cleaning the filter by running it under water, make sure to dry the filter thoroughly before reinstalling.
If the filter becomes extremely dirty, we recommend that you replace it with a new one.
●
Look for the "
" markings on the top of the
filter.
●
Insert the filter into the unit using the two small
protrusions as a guide, as shown in the figure.
Push the filter into the slot until it clicks into
position.
✲
Never use your NEOREST without a filter as
this may cause a malfunction.
"Click"
Protrusions
